Top
All Channels
50°

Setup Octoprint for the Anet A8 with a Raspberry Pi

Electromaker writes: "The Anet A8 3D printer that we reviewed in early 2018 is a bit of a beast for under $150, it produces decent quality prints and it is relatively easy to build. It may be a basic printer, made to a price point but we found that it was a reliable workhorse for makers."

Read Full Story >>
electromaker.io
Create Report !X

Add Report

Reports

+ Updates (2)- Updates (2)

Updates

Changed from Pending to Approved
Community59d ago
Changed: content
sonicwrecks59d ago
The story is too old to be commented.